"Bai Yun" Fire Control Cabinet Series
Input time:2009-11-20

  According to the State Fire Code design, control cabinet controller Siemens products, the main circuit components using Fuji products, the remaining components of domestic famous quality products used. With regular inspection and comprehensive protection; a signal input Kai fire pumps, fire alarm signal output, fire pump start / stop signal output such as an external terminal.

  The Fire input signal, fire the output signal, running status output signals are passive signal.

  Control cabinet functions:

  (1) Operating mode: with manual, automatic two kinds of work.

  (2) operating mode: each other"s backup operation mode, a main one preparation, when the main pump fails, the standby pump starts automatically delayed to ensure that water from fire service requirements.

  (3) Start way: by the chassis panel manual switch to start the fire hydrant, fire center start.

  (4) direct the functions: a power supply, voltage, current direction, pump status indicators, fire instructions.

  (5) Automatic inspection function: according to specification and use of fire, set inspection time, such as the weekly automatic inspection of 10:00, 1 # pump to run 5 minutes after the stop, delay start 2 # pump , run 5 minutes after the stop, and so on, until finally a pump test is completed.Inspection when the pipe network in order to prevent excessive damage to the pressure pipe network, automatic inspection when pressure relief, control cabinet specifically for the user to prepare inspection passive switch signal, by the user according to their own use of pressure relief devices.

  (6) Protection function: over-voltage, under voltage, overload, short circuit, lack of equal protection.

  (7) input and output signal terminals: According to the fire requirements, control cabinet with the fire signal input and output terminals, pump status output, inspection signal output terminals, inspection and other relief signal output terminal.